For this assignment, you will complete a community risk reduction (CRR) assessment as well as a department assessment. To prepare for writing these assessments, it is recommended that you review the Required Unit Resources-refer to Chapter 20 and Chapter 24 in your textbook, as well as the . Also, you will need to write a vision statement and a mission statement.
These are briefly described in the unit lesson. Also, vision statements are discussed in the textbook in Chapter 24’s “Creating the department’s ideal future through proactive futuring” section, while mission statements are discussed in the textbook in Chapter 2’s “Establishing direction” section and in Chapter 24’s “Developing the mission of the fire department” section. You can also search for websites that provide additional information about developing mission and vision statements.
Begin your assignment with a title page that includes the name of your community and the words Department and Community Risk Reduction Assessments. Include a reference page at the end that lists all resources from which you obtained information in correct APA format.
Your assignment will consist of the four parts described below. Complete all parts separately; then combine them into one document. Ensure that the four parts are clearly identified as Part I, Part II, Part III, and Part IV.
Part I: Mission and Vision Statements
Include a new or revised mission statement for your organization as well as a vision statement for your department. The mission statement and vision statement can be on the same page.
Part II: Strategic Planning
This part will explain how your CRR assessment can support your department’s strategic planning. Part II should be at least one-half page, single-spaced.
Part III-Assessment of Your Department
Include section headers to identify each of the following areas. Write your content using proper paragraph format, including bullet points as appropriate. Part III should be at least three full pages, single-spaced, and must address the following:
Emphasis on safety and health and reducing risks
Explain what is done to ensure that firefighter safety and health as well as risk reduction are primary values of the department. Provide suggestions to enhance these as primary values.
Explain how your department ensures that every member understands and complies with the department’s emphasis on safety and health and risk reduction. Provide suggestions to enhance how this is accomplished.
- Responsibility for advocating safety policies and procedures
- Explain how your department ensures that all officers understand their personal responsibility to advocate the department’s safety policies and procedures. Provide suggestions to enhance this understanding.
- Accountability for compliance with health and safety policies
- Explain how your department members are held accountable for compliance with the department’s health and safety policies. Provide suggestions to improve how this is done.
- Fire Chief’s acceptance of responsibility for reducing department risks
- Explain how the fire chief has demonstrated acceptance of the responsibility for reducing risks within the department.
- Explain what you would do to as fire chief to demonstrate this.
- Part IV-Community Risk Assessment
- Include section headers to identify each of the following areas. Write your content using proper paragraph format; use bullet points as appropriate. Part IV should be at least three pages, single-spaced.
- Identify Risks
Include information that can help identify specific risks. Examples are listed below. Feel free to include additional relevant information.
Incident dates and times
Incident types
- Incident locations
- Causes of fires
- Mortality rates
- EMS mechanisms of injury and causes of illness
- Prioritize Risks
- Include information that can help identify specific risks.
- Identify five target hazards in your community. Categorize each hazard as low, moderate, high, very high, or moderate to extreme. Explain why the hazards were placed in the categories you chose for them.
- Identity at least two potential environmental hazards. Categorize the hazards occurrence as probable, likely, or very likely. Explain why the hazards were placed in the categories you chose for them.
- Risk Assessment Examples.
- Include information that can help identify specific risks.
- Construct a demographic profile chart of your community, similar to this: (Do not use the City of Bolton information from the website or the University City information from the sample; fill in the table with your own community’s demographics.) You will find information for your demographic profile on the .
- Discuss/list your fire department resources; do not include information on service areas. This should be formatted similarly to what is shown for this section in the sample. (Use your own information-do not copy the apparatus and personnel listed in the sample.)
- List and discuss the top three risk priorities for your community. These should be formatted similar to the Community Risk Priorities examples at the .
- Your final assignment should be at least seven pages in length, not counting title and reference pages. Be sure all content is well-structured using paragraphs and bullet points.
- To get a general visual idea of how to format your assignment, view the . However, depending on your information, your document may look a little different, which is fine as long as you provide the required information in a similarly organized format.
complete a community risk reduction (CRR) assessment
We offer the best custom writing paper services. We have answered this question before and we can also do it for you.
GET STARTED TODAY AND GET A 20% DISCOUNT coupon code DISC20
We offer the bestcustom writing paper services. We have done this question before, we can also do it for you.
Why Choose Us
- 100% non-plagiarized Papers
- 24/7 /365 Service Available
- Affordable Prices
- Any Paper, Urgency, and Subject
- Will complete your papers in 6 hours
- On-time Delivery
- Money-back and Privacy guarantees
- Unlimited Amendments upon request
- Satisfaction guarantee
How it Works
- Click on the “Place Order” tab at the top menu or “Order Now” icon at the bottom and a new page will appear with an order form to be filled.
- Fill in your paper’s requirements in the "PAPER DETAILS" section.
- Fill in your paper’s academic level, deadline, and the required number of pages from the drop-down menus.
- Click “CREATE ACCOUNT & SIGN IN” to enter your registration details and get an account with us for record-keeping and then, click on “PROCEED TO CHECKOUT” at the bottom of the page.
- From there, the payment sections will show, follow the guided payment process and your order will be available for our writing team to work on it.